Home > Tools >

Flywheel Puller
Flywheel Puller
 
Our Price: $22.05

Stock Status:In Stock

Part #: 7250
Qty:

Description -
 
Flywheel Puller
This flywheel puller is designed for those who don't want to use the "knocker" method to remove their flywheel.

Works with:
  • All ARC flywheels
  • PVL flywheel for clone
To use: Install the threaded rods into clean, lubricated puller holes on a hub or flywheel face. Be sure to thread in the rods fully. Slide the puller block over the threaded rods, and screw the nuts down evenly. Tighten the nuts evenly back and forth in 1/2 turn increments until the flywheel pulls off. Stubborn flywheels may require that you hit the center of the puller block with a hammer once significant pressure is applied by tightening the nuts. Be careful not to strike the threaded rods (use a spacer if necessary), and never hit the flywheel itself with a hammer.

Heat as low as 300°F will damage the rare-earth magnet in flywheels. Do not use a torch.

NR Racing is not responsible for any damage caused to any product by using this tool, so please be careful with use.

Share your knowledge of this product. Be the first to write a review »